Demo Board and CAN

propCan - USB CAN Controller

Hardware by

KZ0Q

A low-cost, high speed CAN Controller for AMSAT

CAN Interface for Propeller DEMO Board is the a identical parts-set to the PropCAN device but only the CAN back-end. This interface was developed in order to prototype and debug initial propCAN firmware using the Parallax Propeller DEMO board. This allows a number of diagnostic interfaces to be utililized without our having to write them. (Since many objects exist for the demo board.)

propCan Controller Website Copyright © 2007, by Stephen M Moraco, KZ0Q E-mail: kz0q at AMSAT dot org

Visit our CAN-Do! Project website at http://can-do.moraco.info Page Updated: 21 Feb 2007, 22:41 MST

CAN Bus I/F for the Propeller Demo Board or any board taking pins on 0.1" centers. LEFT: edge-on view showing both headers primary (down facing) and optional (up-facing) TOP RIGHT: top view showing parts layout and optional pins header. BOTTOM RIGHT: bottom view showing parts layout and primary header.

This is prototype implementation of the schematic found with the MCP2515 SPI object at the Propeller Object Exchange

More pictures can be found in our gallery.